WE need a bit of support so when you go to the site you will know what it means ;-),even if you just want to see the it,it helps us pay the server bills ! and doesn't cost you anything but a little good will which we need !
It's a Thank You for the uploads ^
Check our recently open Blog About Computing !
Use Peer Guardian 2<*[PG2 Home Page]*>To protect Your Self While Downloading off P2P
Recover Data from a broken RAID Level 5 or 0 Array
Runtime's RAID Reconstructor will help you to recover data from broken
* RAID Level 5 Array consisting of 3 to 14 drives
* RAID Level 0 Array (Striping) consisting of 2 drives
Even if you do not know the RAID parameters, such as drive order, block size and direction of rotation, RAID Reconstructor will analyze your drives and determine the correct values. You will then be able to create a copy of the reconstructed RAID in an image file or on a physical drive.
Once you created an image you can use it for further data recovery processing with Runtime's GetDataBack. If you create the image on another physical drive, you can process it with GetDataBack too or you might even be able to directly boot from it.
RAID Reconstructor is Read-Only
It will not try to "fix" your RAID. It will merely create a copy of your RAID at another location. It will collect sector by sector from each single drive involved and write these sectors in the correct order to the designated destination. This process is also called "de-striping".
Because one drive is redundant in RAID 5, it is sufficient to have one less than the original number of drives (N) in the array. RAID Reconstructor can recalculate the original data from the N-1 drives. For a RAID-0 (striped) array you will need both drives.
The RAID Reconstructor will recover both, hardware and software RAIDs. It will recover from broken Windows Dynamic Disk sets.
32 MB Ram
Windows 95, 98, ME, NT, 2000 or XP
Disk controller card capable of handling all the drives in your RAID individually
Storage space for holding the reconstructed RAID