FS2004 FSUIPC_v 3 52+Serial_Working zip

  • Download 5x Faster
  • Download torrent
  • Direct Download
  • Rate this torrent +  |  -
FS2004 FSUIPC_v 3 52+Serial_Working zip

Download FREE And Anonymously

Torrent info

Name:FS2004 FSUIPC_v 3 52+Serial_Working zip

Total Size: 1.45 MB

Magnet: Magnet Link

Seeds: 0

Leechers: 0

Stream: Watch Full Movie @ Movie4u

Last Updated: 2011-01-02 08:44:03 (Update Now)

Torrent added: 2009-08-26 10:57:58

VPN For Torrents

Torrent Files List (Size: 1.45 MB) (Files: 1)

1.45 MB

Announce URL:

Torrent description

INFONEW FSUIPC.DLL replaces FS6IPC.DLL for use with FS98/FS2000/FS2002/FS2004 (reverse compatibility for FS98 add-ons) December 21th 2005 (1.52 MB)FSUIPC release 3.52 1. The 3.51 fix in the wind smoothing algorithm was in error, making matters worse rather than better. In 3.52 the correct fix has been found and applied. In this version the winds, when smoothed, still have the correct cross and head components, and the results when the direct wind control option is exercised (as by ASV) are also good without the sudden swings in direction. Even better, the problem with direct wind control on the ground has been fixed, so everything is now fully compatible. 2. In FS2004 the FSUIPC Wind options page now sports a new option, on the right-hand side, to limit the amount of wind variance which can be applied by external weather programs. Wind variance is fluctuation in wind direction. It is suppressed completely in any case if you suppress all gusts, but otherwise it isn't subject to smoothing. The new option allows the user to enforce a limit on the wind variance being set by external weather programs. The limit placed on variance is progressively lower as wind speed increases. Winds of 0?5 knots will be allowed to vary fully, but 100 knot winds will have the variance limited to 10 degrees either way. This option is off by default, and is saved in the INI as LimitWindVariance. 3. The facility to disconnect the joystick axis controls (offsets 310A and 310B in the FSUIPC interface) is extended to allow this disconnection not to be applied to the older FS98-compatible axis controls, These are: AILERON_SET ELEVATOR_SET ELEVATOR_TRIM_SET RUDDER_SET THROTTLE_SET and the four THROTTLEn_SET controls. This is intended to allow those add-on aircraft that implement their own Autopilot to use these controls to set the relevant values, instead of writing them directly to the specific offsets. To activate this facility the program/gauge/module must set the 2^1 bit in the byte at offset 3109, at the same time as setting the axis connection override bits in 310A/310B. The setting expires in the same interval. Note that if the users of such aircraft calibrate the four separate throttles in Page 3 of the FSUIPC options they will also need to check the option at the bottom of that page, to prevent FSUIPC changing the THROTTLEn_SET values sent by the separate autopilot. Enjoy!Maximus-

related torrents

Torrent name

health leech seeds Size

comments (0)

Main Menu